描述: |
窗户装置 Okoma UF 2 EG mit Schleifeinheit
二手机
Number of spindles: 3 St. Number of tools: 2/3 St. Spindle
diameter: 40/50 mm 1 OKOMA folding machine model UF 2
EG ------------------------------------- 1. Energy
data:
- Operating voltage: 3 phases, 380 V, 50 Hz. -
Compressed air: Air requirement: 13 NL/min.
Operating pressure: 8 bar up. Air: according to Pneurop
6611
2. Profile spindle 1:
- Spindle arrangement:
right - Power 11 kW - Speed 7000 rpm - Direction of
rotation: synchronous and counter rotation - Spindle diameter 40
mm - Usable length 252 mm - Tool diameter max. 230 mm -
U-movement of the profile spindle - Positioning vertically
Drive: pneumatic cylinder 120 mm cycle for 2 tool
positions Position sensor: limit switch
- Positioning
horizontally Drive: Pneumatic cylinder forward-back
Position sensor: limit switch
- Automatic immersion:
immersion speed can be regulated for tear-free Fold
over
- Protective and suction hood with connecting piece 140
mm diameter.
3. Profile spindle 2:
- Spindle
arrangement: right - Power 11 kW - Speed 7000 rpm -
Direction of rotation: counter rotation - Spindle diameter 50
mm - Usable length 272 mm - Tool diameter max. 230 mm -
U-movement of the profile spindle - Positioning vertically
Drive: pneumatic cylinder 90 mm cycle for 3 tool positions
Position sensor: limit switch
- Positioning horizontally
Drive: Pneumatic cylinder forward-back Position sensor: limit
switch - Protective and suction hood with connecting piece 140 mm
diameter.
4. Fitting milling device EG:
- Spindle
arrangement on the right - Drive: three-phase motor 3 kW -
Speed 6000 rpm - Spindle diameter 30 mm - Usable length 47
mm
- Vertical positioning: none - Positioning
horizontally Drive: Pneumatic cylinder forward-back
Position sensor: limit switch (rear only)
- Protective and
suction hood with connection piece 80mm diameter
5.
Stop:
- 1st stop: in front of spindle 1
manual chip removal Quick
adjustment via. parallelogram - 2nd stop: between spindles 1
G512123 and 2 Chip removal: pneumatically
adjustable - 3rd stop: after spindle 2
Fixed stop
6. Grinder with automatic immersion and
immersion
7. Feed:
- Roller distance from axle
to axle 130 mm - Roll diameter 110 mm - Roll width 50 mm -
Feed can be swiveled away - with pneumatic travel
control
8. Support rail for milling:
- Rail length:
approx. 3000 mm - Adjustment range forward: approx. 100 - 600
mm
9. Electrical control:
- Programmable logic
controller: Siemens electronics PC control, 30 programs, 380
V., 50 Hz. - Power section: Siemens S 5 - Non-contact limit
switches
More pictures on
request! --------------------------- (technical data according
to manufacturer - no guarantee!)
The data
for this ad was created with ModulMWS - the software solution of
LogoTech oHG.
seller offer No. resale 1305-6828
|