描述: |
Baler with 10-fold cross tying system and conveyor BOA Recycling Systems B.V. Impress D130.110.B.5-(5R).1.6
二手机
A complete baling press system is for sale, consisting of a chain belt
conveyor, the baling press with wire stations and bale
chute.
Technical data baler: Manufacturer BOA Type
Impress D130.110.B.5-(5R).1.6 Year of construction 2009 Press
power main press 127 tons Specific press capacity 10,7
kg/cm² Working pressure 280 bar Feed channel 1.620 x 972 mm
(l x w) Press volume / cycle 4,1 cbm Volume throughput without
load up to 865 cbm/hour Cycle time under operating conditions 22
sec. Press stroke 2.900 mm Bale size 1.100 x 1.100 mm (w x h)
length adjustable Driving power 2 x 55 kW Connected load 132
kW Tying system 5-fold vertical, 5-fold horizontal, fully
automated Throughput rate at a bulk weight of 30 kg/cbm up to
17 to/h bulk weight of 50 kg/cbm up to 29 to/h bulk weight of
100 kg/cbm up to 37 to/h bulk weight of 150 kg/cbm up to 51
to/h Bale weight up to 1.200 kg Volume hydraulic oil tank
1,850 L SPS controller Siemens S 7 Operating panel
SiemensToughscreen Multi Panel Transport dimensions baler approx
12.741 x 2.400 x 3.360 mm (l x w x h) Machine weight baler approx.
50 tons
Technical data for the conveyor belt Manufacturer
BOA Type 1700 HBS 32° KTH 11000 x 13076 x 1500 Year of
construction 2009 Drive power 11 kW Variable belt
speed Feed conveyor length 11,000 mm Length of ascending belt
13,076 mm Pitch 32° Useful width 1,700 mm Height of side
wall of infeed conveyor, inside 800 mm Height of side wall of
ascending conveyor, inside 500 mm Pit dimensions to conveyor belt
14,616 x 3,550 / 2,150 O651246 x 1,750 mm (l x w x
d)
Comments: As you can see from the photos, this machine
has some signs of wear that should be repaired and removed before it
is used again. A basic maintenance and partial overhaul is
recommended. The cylinder tube of the main hydraulic cylinder has a
hairline crack and should definitely be replaced. The machine is
expected to remain in single-shift operation until May and will then
be replaced by a new press with conveyor belt.
An inspection
of the machine during operation, including the use of materials, is
possible by appointment. We accept no liability for the technical
details or any errors. seller offer No. resale
BOA_Impress_D130_yoc2009_10-fold_cross_tying_syste
|